Home | View Cart | My Account | Order Status

Search

Sump pumps

Home »

Wayne Home Equipment CDU800-56270 Cast-Iron Submersible Sump Pump

Wayne Home Equipment CDU800-56270 Cast-Iron Submersible Sump Pump

(13 customer reviews)

List Price:	$159.00
Our Price:	$147.93
You Save:	$11.07 ( 7%)

SKU:

448370

In Stock

Usually ships in 1-2 business days

Description:

1/2hp cast sump pump. CDU 790. 2-pole switch...positive On/Off action. Disconnecting 115V conductors prevent lightening damage. Float...automatically starts and stops pump. Operates vertically to save space. Automatic overload...prevents damage to motor

Features:

•

1/2hp cast sump pump

•

CDU 790

•

2-pole switch...positive On/Off action

•

Disconnecting 115V conductors prevent lightening damage

•

Float...automatically starts and stops pump

Product Details:

Product Length:	9.0 inches
Product Width:	9.0 inches
Product Height:	12.0 inches
Product Weight:	17.8 pounds
Package Length:	14.0 inches
Package Width:	10.0 inches
Package Height:	9.9 inches
Package Weight:	19.35 pounds
Average Customer Rating:	based on 13 reviews

You may also like ...

Wayne Home Equipment ESP25 Battery Backup Pump System

$249.15

Customer Reviews:

Average Customer Review: 4.0

( 13 customer reviews )
Write an online review and share your thoughts with other customers.

Most Helpful Customer Reviews

11 of 11 found the following review helpful:

Bad impeller design, cheap plastic spins free on motor shaft.Apr 20, 2010
By Redhead_men "Redhead_men"
Within 1 months time I had 2, 1/2 half horse power cast iron sump pumps flood a basement because the plastic impeller connection to the motor shaft had enlarge to the point where it spun free on the shaft. They were both the previous version of the 1/2 HP cast iron pump. The CDU800 has the same plastic impeller. One pump was 3 years old from date of manufacture, the other 17 months. Both locations only pump ground water and run just occasionally when it rains hard. Without any local parts and service agents, you have to buy new and then order parts and repair if possible. Having the cast iron housing and stainless screen mean nothing if the impeller is just plastic junk. My previous Zoller pumps had lasted more than 10 years. They were made in America. Wayne leads you to beleive that they are made in America & Canada, but a local pump repair shop said they were Chinese pumps. Parts are only available from Wayne and it takes 5 days to ship from Hamilton Ohio (or whereever) to Indianapolis Indiana. Replaced both with Zoller, But I am not sure these are even made in US any more.

3 of 3 found the following review helpful:

great pumpApr 11, 2010
By The Captain "Rich"
This is the third Wayne pump I have purchased for my french drain in basement over the last 18 yrs. They have all worked very well and are very dependable. I always replace after 6 yrs for peace of mind . Always make sure the pump is sitting straght up for the float to work properly.

3 of 3 found the following review helpful:

Quite and powerfulDec 10, 2009
By Chief
I bought and installed the Wayne 1/2HP sump pump 2 years ago in my basement sump pit. I replaced a 20 year motor that had finally stopped, due to muck at the bottom of the steel lined pit. The only purpose of this pump is to push out the water generated from my furnace and the humidifer that goes into the floor drain and then into a 55 gallon sump pit. No outside drainage tile. So the pump only operates about 7 times a week and pumps out the water out into the sewer line which is located 8 feet above the pit. A powerful pump that works quickly when needed. No problems

1 of 1 found the following review helpful:

Dependable pumpNov 16, 2011
By ash115
I have used Wayne sump pumps for about 13 years. The last pump was replaced after 7 years as it was run excessively. It still pumped, but was beginning to slow down during major rain storms. The cast iron pumps have a better warranty so those are the ones to install.

1 of 1 found the following review helpful:

Astonishingly quick delivery!Jun 28, 2011
By Richard A. Rechel
Rec'd item about 24 hours after ordering online, even though there was no rush and I didn't request (or pay for) any special shipping. Seems to be very high quality product; working well for a couple of weeks now (too soon to comment on longevity). Modified a bit (with a spacer on wire above float) to turn on at about 7 1/2" instead of about 9", but think I'll go back to around 8" or 8 1/2" as I think it cycles on and off a bit too quickly for what I want. What a pleasure to find something actually made in the USA!

See all 13 customer reviews on Amazon.com