Home | View Cart | My Account | Order Status

Search

Housewares and small appliances

Builders hardware, hinges, door knobs

Shower heads and bathtub faucets

Garbage disposers, water heaters and softeners

Fireplace ash doors and dampers

Kitchen and bath faucets and parts

Plumbing tools and accessories

Dundas Jafine UD48S 90 Inlet Aluminum Dryer Vent Duct

Dundas Jafine UD48S 90 Inlet Aluminum Dryer Vent Duct

(2 customer reviews)

List Price:	$32.99
Our Price:	$29.65
You Save:	$3.34 (10%)

SKU:

273386

In Stock

Usually ships in 3-4 business days

Description:

28/45 90 in/strt ot duct. Space saver aluminum dryer venting duct. Extends 28" to 45". Allows dryer to be placed 3" from wall. Constructed of a 2-piece adjustable aluminum duct. Ideal for use in tight space with ceiling or wall installation. 90 inlet/9

Features:

•

28/45 90 in/strt ot duct

•

Space saver aluminum dryer venting duct

•

Extends 28" to 45"

•

Allows dryer to be placed 3" from wall

•

Constructed of a 2-piece adjustable aluminum duct

Product Details:

Product Weight:	2.0 pounds
Package Weight:	3.0 pounds
Average Customer Rating:	based on 2 reviews

You may also like ...

Culligan FM15RA Culligan Faucet Drinking Water Filter Cartridge

$15.51

Customer Reviews:

Average Customer Review: 4.0

( 2 customer reviews )
Write an online review and share your thoughts with other customers.

Most Helpful Customer Reviews

2 of 2 found the following review helpful:

Does what it does wellOct 15, 2011
By usaf_drew
This basically does what it's supposed to - saves space and allows you to move the dryer close (3-5") to the wall. However, be sure to use plenty of HVAC tape on all the seams as they are just tack welded and crimped together. I even went sofar as to use some tape inside the unit where the collar mates with the periscope section because it's more of a slip on connection. Once at the correct height and all taped up, airflow will be quite good through it. One thing of note is the collar that attaches to your dryer is a bit short. Wasn't an issue for me, but if your dryer's exhaust is not protruding or flush with the rear, you will have to get a coupler which will defeat the purpose of this. I also used a worm drive clamp on this for good measure. For those worried about how this design will affect the overall length of their dryer exhaust run, it worked just fine for me in a 35' overall run w/ one 90. I would have given this 5 stars if it were not for the prep time it took with HVAC tape to get this installed.

2 of 2 found the following review helpful:

UD48SAug 28, 2011
By NY TriState Buyer
Good value. The quality could be a notch or two higher. After adjusting to desired height it's a good idea to seal it with high temperature service HVAC tape.